Build a wine rack – with a little help from Mitre 10.
There are hundreds of off-the-shelf wine racks to choose from, but if you prefer one that matches your decor or your personality you may have to make it yourself with our step-by-step guide.

Download PDF (1.3Mb)

Copyright Mitre 10 Australia Pty Ltd. Reproduction prohibited other than for personal use. Information intended as a guide only and should not be relied upon without further enquiries for your specific purpose. All liability for any loss or damage incurred from reliance upon this information is excluded.

Get a quote

To get everything you need, select the items from the list below and hit get a quote.

Everything you need

Product Checklist

		1/ 3.6m length of 240 x 19mm radiata pine
		1/ 1.2m length of 19 x 19mm radiata pine
		1 small pack 50 x 2.0mm bullet head nails
		1 small pack 30mm x 8G wood screws
		1 small tube of wood stop (putty): colour to match timber or stain
		500ml Wood stain (colour of choice)
		500ml Clear satin polyurethane
		Sand paper - 80/120/280/400 grades

Tools for the Job

	Tape measure
	cordless drill / driver and bits
	Hand saw or power mitre saw
	Claw hammer
	Nail punch
	Sanding block4cm dowel
	Sandpaper (80, 120, 280, 400 grades)
	Try-square
	Putty knife
	75mm paint brush
	Rags

Print