Create an insulated home theatre room – with a little help from Mitre 10.
To get the full benefit from digital surround-sound media, games and equipment you need reasonable volume. This often includes substantial low-frequency (bass) noise that can be very annoying to other occupants or even neighbours. With Mitre 10 you can design a home theatre room with effective sound installation.

Download PDF (2.2Mb)

Copyright Mitre 10 Australia Pty Ltd. Reproduction prohibited other than for personal use. Information intended as a guide only and should not be relied upon without further enquiries for your specific purpose. All liability for any loss or damage incurred from reliance upon this information is excluded.

Get a quote

To get everything you need, select the items from the list below and hit get a quote.

Everything you need

Product Checklist

		Boral “Sound Stop” plasterboard (10mm or 13mm)
		Fletcher Insulation “SonoBatts”
		Plasterboard screws, paper tape, stud adhesive, total join finish, cornice cement
		String and staple-tacker
		1 / 2.4 x 1.2 x 32mm raw MDF
		1 / 2.4 x 1.2 x 18mm raw MDF
		1 small pack of 50 x 8mm fluted dowels
		1 small pack of steel-pin shelf rests (at least 10)
		1 small roll of iron-on vinyl edging (at least 4m)
		4 / 30mm hooded castors (spindle or plate mounted)
		Wood stain (colour of choice)
		Clear polyurethane, or acrylic paint of choice
		PVA adhesive
		120, 240 grit sand paper

Tools for the Job

	Measuring tape
	Straight edge & clamps
	Pencil
	Circular saw
	Cordless drill bits
	Screwdrivers
	Dowel boring jig and dowel “pops”
	Claw hammer
	Fine nail punch
	Set of broadknives for setting plaster
	Coping saw
	Trestles
	Pinch bar
	32mm bevel-edged chisel
	Sanding cork
	Painting and staining equipment
	Sacrificial straight timber for cutting on

Print